The new Mondeo wins is a new car released by Ford on March 17, 2011. It is the model with the highest technology content of Changan Ford. Mondeo has made 232 engineering changes in the aspects of body, interior and exterior decoration, parts design, manufacturing process and materials.
Moreover, the 2.0 l direct injection turbocharged engine and the six speed dual clutch transmission are the latest technologies of Ford. It takes 8.3 seconds to accelerate 0-100 km / h, and the fuel consumption is 7.9 L / 100 km / h.
The 2011 Mondeo Zhisheng was officially launched in China on March 17, 2011 Design dynamic design route, the appearance of the new model has been changed. The most obvious change is the area proportion distribution of the front air intake grille. The area of the upper air intake grille is reduced while the area of the lower air intake grille is increased. The hexagonal trapezoidal middle net makes the whole front face look more stable, and the front and rear light groups adopt the current popular LED lamp group design. In addition, the new car tail has also been adjusted, using a new rear bumper and rear reflector. Ford Mondeo modified airbft pneumatic shock absorber high configuration refitting kit, with memory function, can realize four wheel independent lifting, four wheel independent fine tuning, front wheel lifting at the same time, rear wheel lifting and four wheel lifting at the same time. Ford Mondeo modified airbft pneumatic shock absorber, feel the low lying driving comfort!
安装气动避震大致分为4个板块，也就是气动避震的安装，管路的铺设，线路的走位，和控制系统的安装！
下面就来一步步的分解一下：
The installation of pneumatic shock absorber is divided into four parts, that is, the installation of pneumatic shock absorber, the laying of pipelines, the travel of lines, and the installation of control system!
Let's break it down step by step
Let's talk about the installation of pneumatic shock absorber. The installation of pneumatic shock absorber barrel body is actually the same as that of replacing ordinary hinge suspension. Shock absorbers are all the installation positions of the original vehicle. It should be noted that the highest and lowest range required by the owner of the vehicle should be calculated according to the shock absorber travel, so as to adjust the height of the solar shock absorber, as well as the reserved position of the air pipe. Generally, the air pipe moves on the inner side The rest is to follow the normal shock absorber installation procedures.
The laying of pipelines and pipelines is a time-consuming work. The methods and ideas of each installation master are different. However, one principle should be followed, that is, to avoid the places that may be bent dead or where the vehicle may be pressed or ground to the air pipe, and that is, to keep away from the exhaust gas, because the material of the gas pipe is prone to high temperature, the best way is to It's going with the tubing.
When the line moves, the line usually goes in the car, along with the electrical circuit in the car, which is quite troublesome, because it is necessary to dismantle a lot of interior parts. It is better not to cut off the main power line. In addition, if there are other electrical equipment in the car, the power line must not be shared to prevent mutual interference.
For the installation of control system, airbft pneumatic shock absorber control system is a simple control system. However, if you want to perfect the installation, you need to have some experience, because there are many details that need to be paid attention to, especially the screw thread connection of each joint, air pipe and air hole, should be carefully installed. The screw tooth connection of air hole and joint must be well sealed, and if there is leakage Gas condition, and then check the test, is very troublesome, as far as possible one step in place.
Company name: Shanghai Songjiang shock absorber Group Co., Ltd
English Name: airbft
Address: Shuangdian Industrial Park, Nantong City, Jiangsu Province (Nantong factory of Songjiang group)
Company website: http://hellaflush-china.com Pneumatic shock absorber Forum
Company contact: 13262966665
Email: 981731567@QQ.com
